Baracoda ToughRunners Manual de usuario Pagina 20

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 26
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 19
Communication Protocol for Baracoda ScanWear/ToughRunners Scanners
Sept. 07 20/26
Command Header Length Payload Answer
Get sniff 0x10 00 00 0x10 00 08 [MSB of MinSniff interval, LSB of MinSniff
interval, MSB of MaxSniff interval, LSB of MaxSnif
interval, Sniff Attempts MSB, Sniff attempts LSB, Sniff
timeout MSB, Sniff timeout LSB]
When setting only MinSniff and MaxSniff values, the default value 0x08 will be used for
Sniff attempts and Sniff timeout.
Typical values are:
Full speed (full power)
MinSniff = 0
MaxSniff = 0
Very Low Power (low speed): (sniff of 500ms Only are accepted. If the remote device
does not support sniffs of 500ms, no sniff will be used)
MinSniff = 0x0320
MaxSniff = 0x0320
Very Low Power (low speed): (sniff between 250ms to 500ms are accepted. No sniff will
be used if the remote device does not support any sniff values in this specified range)
MinSniff = 0x0160
MaxSniff = 0x0320
Low Power (medium speed):
MinSniff = 0x0050
MaxSniff = 0x00F0
Attempt = 0x0008
Timeout = 0x0030
MaxSniff and MinSniff are only used for sniff negociation between the Smartodule and the
other BT device. If both sides allow sniff value MaxSniff, then MaxSniff will be used. If
the other side does not accept Sniff values MinSniff to MaxSniff, no sniff will be used.
Values are in number of Bluetooth slots (1 slot = 625s)
Set MinSniff and MaxSniff to 0 to disable Sniff.
MinSniff must be inferior to MaxSniff.
Possible values for MinSniff and MaxSniff are 0x12 to 0xFFFF.
Sniff attempts of 0 is not allowed.
Warning: Setting MaxSniff to 0xFF means a sniff period of 40s! You will have very very
low data rate.
Note: This setting takes effect immediately.
Attempt Negociated Sniff
For further details on Sniff values, see the Bluetooth spec 1.1, chapter 10.8.2
Command Header Length Payload Answer
Set link
timeout
0x19 00 02 [MSB of link Tmo, LSB of link
Tmo]
0x19 00 01 01 if
done
0x19 00 01 00 if
not
The link Time Out is a multiple of 625sec (625s = 1 Bluetooth slot) (default 0x7D00
(=20s))
Vista de pagina 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Comentarios a estos manuales

Sin comentarios